Precision Brush

Design an Inside Disk Brush | Precision Brush

Design a Inside Disk Brush

Play Video

Start Designing Now:

Loading Form...

Inside Disk Brush

Inside disk brushes are very similar to inside coil brushes except they are comprised of just a single disk.

These specialty brushes start out as a straight strip brush. Using our custom brush manufacturing machinery, we wind the straight strip brush into a wound cylinder shape and then flatten it into a disk.

As with all our brushes, their use is limited only by your imagination. That said, one common industrial brush use for the inside disk brush is with a moving shaft. If you want to keep spray or debris on one side of the moving shaft, an inside disk brush is a good way to create a seal, especially if there’s a little bit of unevenness in the surface of the shaft (such as from rivets, bolts, or surface contours). A fixed rubber seal will wear out more quickly and leave gaps, allowing spray or moisture to escape.

Sometimes inside disk brushes are also used to clean or prepare a shaft that is being pushed through the brush.

Start your custom brush design now by completing the form below. If you’d like support from one of our experts, just give us a call.

Interested in a Free Quote?

Request One Now!
Copyright © Precision Brush, All Rights Reserved
6700 Parkland Boulevard, Solon, OH 44139 USA
Local: (440) 542-9600 | Toll Free: (800) 252-4747 | Fax: (800) 252-0834
Powered by Virteom